SparkFun Battery Holder - 18650 (PTH) Batteries

SparkFun Battery Holder - 18650 (PTH) BatteriesThis is a PCB mount clip to hold a 18650 Lithium Ion Cell battery. Each battery holder is sold in single units, youll need two for each battery. These work great for larger, high capacity applications where a drop in rechargable cell is needed. These little guys are low cost and easy to use! Note: This part can be found in the Electromechanical Eagle library under Battery18650. Documents: Datasheet Product Video

s cost-effective and actually works really well

The board needs to be powered from the two voltages sources (high voltage and low voltage) that your system is using

Code can be loaded through the FTDI basic interface and the Arduino environment

5V) you can use this on both your 3

Sit this on your workbench and stop worrying about having a piece of wire around

castellated Mounting Holes

We recommend purchasing the related pigtail below or soldering wires directly to the back of the module

54mm pitch pins

With a max voltage rating of 125VAC at 0

3V fixed output voltage

Remember that USB power does have its limitations

Note: This is a 110VAC version and will only work properly on that voltage