(354) IAME KA100 Bushing for Z9 Sprocket

(354) IAME KA100 Bushing for Z9 SprocketThe IAME KA100 bushing for Z9 sprocket is a purpose built spacer bushing required when running the 9 tooth clutch sprocket on the KA100 engine. The Z9 sprocket has a different hub geometry than the standard Z10Z13 sprockets, and this bushing bridges the gap between the Z9 sprocket and the clutch drum bore. This bushing is used in combination with the special Z9 nut and washer (X3012553 US) to complete the Z9 sprocket mounting configuration. Do not

Condition: New — genuine Briggs & Stratton OEM part

The drive sprocket mounts directly to this drum via a needle cage bearing (or plain bearing for the 11T sprocket)

Whether you're chasing laps in Briggs LO206 or running a Honda GX200 clone

The IAME KA100 crankshaft assembly is the complete factory OEM crankshaft for the KA100 100cc reed-jet kart engine

The spring tension determines how aggressively the needle re-seats when fuel demand decreases

Replace the button immediately if it shows any sign of intermittent operation

The IAME KA100 bendix support is the mounting bracket that positions and supports the starter bendix assembly within the starter housing on the KA100 engine

Bluetooth supports heart rate monitor pairing

The piston accepts a 14mm wrist pin (sold separately in "B" or "R" grade) and is retained by two 1

Stiffness: Hard (HD)

Quantity: 1 Tool

This is not a field repair — use proper tooling