Fender Ribbed Duck Billed Rear 7" for All Custom Motorcycles

Fender Ribbed Duck Billed Rear 7" for All Custom MotorcyclesOld's Cool Choppers Fender Ribbed Duck Billed Rear 7" for All Custom Motorcycles 7. 5 inch wide Made from 14 gauge raw steel Thicker material than the norm much easier to run these fenders in a strut less application Ribbed and duck billed rear fender 30 inches from tip to tip Highest peek to tip center is 13. 00 inches Fits high wall side tires great like our 4. 50x18s but also works well on 19 and 16 rear high side wall vintage tires Made in the USA

these levers also have no adjuster nut so they are made for cables with build in adjusters on the cable itself

The "dust shield" sometimes becomes damaged or rusty where moisture has seeped in

and the diameter maximum is 2"

These Motor Mounts are for Triumph 650 units 63-70

*10" from flor to inside ledge (measured right in center of fender)

6” spacers

Perfect weld on rear wheel axle plates for that Triumph 500 or 650 unit or ore unit as well as any custom built British or similar motorcycle

Double hemmed edges with metal grommets in each corner

This will replace your Lucas stator part # 47205

Mild Steel water jet cut

cups and cones that are in a stock Triumph motorcycle neck

Custom colors are available