Silicone Molds

Silicone MoldsTechnical Tip: All PELCO Silicone Rubber Molds are made from the highest quality silicone rubber available. With care they will last a long time. After polymerization in a 60 C oven, let molds cool before removing blocks. This precaution will increase the lifespan of the mold. Using silicone rubber with Spurr's Resin will significantly reduce the lifespan of the molds. Maximum temperature: 218C (425F). PELCO Flat Embedding Molds Blue, White or

Screw used is 6-32 x 1/8

The LockMailer™ can also be used without the tamper proof feature

#130-12H shown holds 18 size 000 capsules

No SiO2 top coating

400 Mesh Center-Marked 1G_400

2 or 2 ml Cryovial® Tubes

15 amp anti surge (T) 5 x 20mm Electrical 110 or 220VAC Power 1A/115W @ 115V

High-quality precision diamond scribing tool from the former Minitool™ line of products in a durable chromium pen housing

It has more facets or cutting edges and keeps its cutting ability by being less friable (easily crumbled or pulverized) than the more common and less costly monocrystalline diamonds

555 has a Flow Point of 120ºF (54ºC)

Intended for the identification of resin-embedded samples in BEEM® capsules

Enables corroborative microscopy