4"SCH40 2pc Alum PP CPx26'0"

4"SCH40 2pc Alum PP CPx26'0"This 2pc 4" Schedule 40 aluminum pole is split for ease of transport. The 20' bottom section features a zinc plated steel end plug, 1 1 4" diameter hole for lifting, and a countersunk 4'0" steel splice. The bottom section has a 22'0" overall length including 2' of the exposed steel splice material. The top section of the pole measuring 6'0" is fitted with a zinc plated steel top pin and countersunk hole for a bolted connection to the bottom section.

This fitting is generally used for gable frame widths that are wider than 15' where intermediate legs are often used

240" wall thickness

Length allowing for use on both 8' and 9'3" legs

This is a replacement strap for the Canopy Jack 13'8"h and 10'10"h sizes

The loop is designed to connect over the eave arm of a Side Tee or Special Side Tee fitting during the assembly process

Clamp is engineered for a 375lb hanging load utilizing a minimum safety factor for allowable load of 5:1

The benefit to using the Mid-Span Tensioner rather than just a strap and buckle comes in the angle of pull of the strap against the eave pipe member

Other straps used in short term applications should be tested periodically to assure that they meet the intended working load for their design

and 40'x50' and larger)

and applications where the stake is fully embedded

when used with the Tidewater Flags

This rope is commonly used for jumper rope applications for pole supported tents