R&D Drive Plate For PRM (10 Teeth Spline, 155.45mm OD, 100 lb ft)

R&D Drive Plate For PRM (10 Teeth Spline, 155.45mm OD, 100 lb ft)13B4 Marine Engine Damper Drive Plate from R&D Marine Fitted between the boat engine and the gearbox input shaft, a damper drive plate is designed to transmit the engine power to the gearbox, whilst reducing transmitted gear noise and providing a cushioned drive when selecting gear. All R and D Damper Drive plates include a 'failsafe' design. Also called the Driven Plate, Damper Plate or Clutch Plate, the 13B4 Damper Drive Plate is from the R and D

Life Cells come with lanyards

Lightweight and easy to transport the Hubi Go has been used in expedition base camps on camp sites for emergency disaster relief situations and in homes and garden building around the world

prevents cycle in small sump installations or enables lower drain than 13mm (1/2")

Slammer III 5500 (641-1403984)

) N-01072 2" BSP 12" (305 mm) 63 mm N-01075 2" BSP 15" (380 mm) 63 mm N-01078 2" BSP 18" (457 mm) 63 mm N-01084 2" BSP 24" (610 mm) 63 mm

Attwood 3" Water Resistant Inline Blower 12V

F35B-9/F35B-903 pumps (10-24178-3)

Installs easily either flush or flat mount

deep and REM sleep stages

switches off at: 20 V

The Quick E3 Eagle 1024D windlass is suitable for boats from 10m to 13m (33 to 43ft)

This sensor is part of a current balance circuit of the fuel gauge display circuit which typically consists of coils for actuation of the display needle