Slide Top Tee- 2" (Red)

Slide Top Tee- 2" (Red)This fitting is used along the ridge of the tent as an intermediate fitting between crowns. It is designed to slide over the outside of the 2. 0" OD ridge pipe to allow the ridge fitting to align with the side tees on the eave of the tent. Commonly it is used on a 10'x20' frame tent where a single ridge pipe is used rather than two shorter rige pipes and a traditional top tee fitting. It is designed for use on traditional west coast style frame tent

or other products should not be used on webbing tie-down components as its use might accelerate this aging process

The top section of the pole measuring 4'0" is fitted with a zinc plated steel top pin and countersunk hole for a bolted connection to the bottom section

The 7' bottom section features an ABS plastic injection molded end plug

000lb breaking strength or a 3

Base Material: 1

000lbs and a working load limit of 1

For stake bar

It can be used on all widths of hip and gable ended traditional frame tents from 10' wide up to 40' wide by varying the length of brace pipe

This 2" x 4" Custom aluminum extrusion is commonly used in frame supported tent systems

This 2pc 4" Schedule 40 aluminum pole is split for ease of transport

The mast features a fully adjustable construction allowing for adjustability between 49

The usable embedment length is approximately 39"