2.2\" 18-bit color TFT LCD display with microSD card breakout

2.2\" 18-bit color TFT LCD display with microSD card breakoutThis lovely little display breakout is the best way to add a small, colorful and bright display to any project. Since the display uses 4 wire SPI to communicate and has its own pixel addressable frame buffer, it can be used with every kind of microcontroller. Even a very small one with low memory and few pins available! The 2. 2" display has 320x240 color pixels. Unlike the low cost "Nokia 6110" and similar LCD displays, which are CSTN type and thus

1mm in a SD card form factor

Adafruit Arduino Selection Guide

You are what you wear

Sensor interface including two buttons and two LEDs

you'll need a remote power supply (see Maxim's product page for more details)

as you need dedicated hardware or a very fast processor such as an FPGA

Reset signal to the shield is now active low (i

This pack is intended for providing power to an iPhone

This one from Adafruit is ideal and has been tested

Cortex-M0+ at 48 MHz is much faster than 8 bit AVR processors at 16 MHz

Assemble your Adafruit Pi Cobbler Kit

there are Power