RX-8 Mazda Steering Rack Stop Set (Lock Limiters)

RX-8 Mazda Steering Rack Stop Set (Lock Limiters)SLR shaft mounted steering angle limiters allow you to dial maximum steering lock without rub, great to stop your racecar from eating the brake ducts, AND drift cars to lay it on lock without worry! Rack shaft stops remove power steering overload from the tie rod when you reach the limit. This stops the power steering from stripping tie rods or bending parts, and reduces failures when hitting bumps at full lock. Fits all RX 8 Currently included in all

This patch wiring harness has been tested and confirmed to work with the following Ecoboost ECUs:

but high strength and stiffness

Multipole Power Connector is genderless

Optimal protection against engine wear

includes onboard 4 bar MAP sensor

Formulated to the highest standards for raw ethanol

17 event wins

5-inch dash display legal for road use featuring 10 RGB shift lights and street icons down the side of the dash

1000cc/min flow rate

**Does not fit S15 6 Speed Transmission

This coolant header tank bolts into the factory LHD S14 240SX Chassis next to the wiper motor allowing you to move the fill point up higher in the cooling system and create a bleed point for the air to be pulled from the engines cooling system

Large enough loop to accommodate most all Tie down strap hooks