Adafruit Audio FX Sound Board - WAV/OGG Trigger with 16MB Flash

Adafruit Audio FX Sound Board - WAV/OGG Trigger with 16MB FlashWould you like to add audio sound effects to your next project, without an Arduino+Shield? Or maybe you don't even know how to use microcontrollers, you just want to make a sound play whenever you press a button. What about something that has to be small and portable? You are probably feeling a little frustrated: it's been very hard to find a simple, low cost audio effects trigger that is easy to use and does not require any programming UNTIL NOW!

so it has a lot of sensitivity at low light levels but is also nearly impossible to "max out" so you can use it indoors or outdoors without changing code or calibration

Power with 5-12 VDC

capacitive touch sensors

420uA@3v OFF mode

VUSB (both for input and output)

Low Power 1

Two are needed for all 16 buffered channels

We're looking forward to seeing what people do with this cool stuff

We picked this set to carry because the drivers have nice rubber grips and long thin shafts for getting into boxes with deeply recessed screws

Display Color: Deep Blue/Light Yellow Green

Flexible and configurable 23 pin GPIO

Easy-to-Use AT Command: Setup ZigBee network