CutKit™ Index Gears

CutKit™ Index GearsThese index gears fit the Vevor faceting machine used with the CutKit as well as other similar faceting machines. Each gear comes with a 4mm allen key for installation. Machines usually come with a 96 degree already installed. Index gears are used to set the rotational angle while faceting. The number of teeth on the index gear controls the type of symmetry you can cut into your stone. The default is a 96 degree which allows for most classic cuts but

Each piece is marked with its weight and you select which one to purchase

I am not even sure of the growth method--it is very long and slender

They recently closed their factory in Chicago and auctioned off the contents

Note its hardness is around 5 so LN is not a good stone for rings but is fine for lower-wear jewelry like pendants

My camera struggles to capture the color change but it is very striking

and has some natural needle inclusions as well

and in the hand the stone is even cooler than the photos can show

It is ideal for use in all kinds of jewelry

While this method is very cheap it has some limitations--it can only produce relatively small pieces and the material produced is not precisely the same as natural spinel

height adjuster

triboelectric and photoelastic among other properties that make it indispensable for all kinds of scientific and industrial applications

With TGG it is possible to make a high-efficiency optical isolator that prevents any of that sort of backsplash