QU50378 NV5600 Mainshaft Center Bearing

QU50378 NV5600 Mainshaft Center BearingQU50378 Timken Mainshaft Center Bearing for Dodge New Venture NV5600 6 speed manual transmissions. Of all the large bearings in the NV5600, the Mainshaft Center Bearing is the most likely to fail in a low oil or contaminated oil situation. This Bearing is located on the mainshaft between the 1st gear Thrust Washer and 1st Gear Snap Ring. Use with QU50377. Country of origin will vary depending on which Timken Plant produced the part.

SEE TECH NOTE 4

Dan the Gear Man Safety Warning: Stock Elastic Stop Spindle Nuts and Lock Wedges used on 1994-2002 Dodge Ram Dana 60

61:1 Ratio Input

QU10121 Steel Spacer

QT1144 1-3/4" Size Front Axle Shaft Oil Seal Remover is used in conjunction with our TS4863 Handle Set to remove the front inner axle shaft oil seals from most popular smaller size SUV's and 4x4 trucks with solid front drive axles

What you need to do is replace the matching gear with a late model gear and purchase a late model ring for that gear

Ram 3500 4x4 trucks with Dana 60 or AAM 9-1/4" front drive axles

Ram 3500 Chassis Cab 4x4: 2007

2 QU50091 Wheel Seals

Ram 2500: All 2006

Video: Removing and Installing Warn M256 Dana 50

Non-Greaseable QU90007 Axle U-Joint