QU40561R Recon 18T Hub Drive Gear for 1st Design Spicer Plastic Dial Hubs

QU40561R Recon 18T Hub Drive Gear for 1st Design Spicer Plastic Dial HubsQU40561R Reconditioned 18 Tooth Hub Drive Gear with Pressed in Bushing for Spicer Plastic Dial Hubs is a used Spicer 1st design, square tooth gear with 19 internal splines used by Ford and GM up to 1977 1978. Available while supplies last. Need More Info? Use the handy Links below to access over 40 years of Dan's product and vehicle specific Tech Notes to easily get the information you need for your vehicle's repair, maintenance, or upgrade project!

Tech Note 1: Must Remove

Tech Note 2: Design

QU11338 Replacement G56 Output Shaft Seal for 4wd 2005 and newer Dodge and Ram G56 6 speed manual transmissions

RAM 3500 Single Rear Wheel Trucks with Rear Drum Brakes

K2500 pickups and Suburbans with GM 10 Bolt Front Axles: 1977

W250 with Dana 44 front axle

Includes press on seal

1978-1979 Bronco

NOTE: CAD Drawing will not show if you reached this page from an Exploded View or Quick View link

QT1071 Adjustable Depth Inner Axle Shaft Seal Installer for all 2000-2002 Dodge Ram 2500 and Ram 3500 trucks with Dana 60 front axles to install QU40298 original equipment CR made seal for the left side axle shaft on all models AND the right side seal for 2002 axles without Central Axle Disconnect (CAD)

outer Rod which is used to drive out seals from the short side on most trucks or both the left and right seals on 1988 to 2002 Dodge Ram full size models with vacuum controlled Central Axle Disconnect (CAD) systems

Of all the NV4500 variants