Indmar Heat Exchanger Zinc Anode Drain Plug

Indmar Heat Exchanger Zinc Anode Drain PlugReplacement heat exchanger sacrificial anode. This is a common zinc anode used on Indmar, PCM, and Challenger engines with the factory half or full closed cooling systems. They are located on the lowest point on the bottom side of the heat exchangers. This drain plug was also used on Challenger and PCM exhaust manifolds as well. Make sure to inspect this zinc annually or every 100 hours of operation and replace it when the zinc is 50% gone. Product

It can also be used for long-term storage and winterization

bend radius)

) Three sizes are available

Dock Buddy stretches for more stability from wakes

Maximum load strength (break strength): 1

the Range ensures comfort

This impeller is VERY RARELY used on Indmar engines

sponge or brush

commonly used on direct drive Malibu Boats

Just spray or wipe Mildew Stain Remover on boat tops

Our traditional cast iron mushroom anchors meet basic anchor requirements and store easily

When we think of Jake Pelot and this Supreme jacket we think of modesty